Bosch GTS 10 XC Professional Manual Original página 33

Technical Data
Table saw
Article number
Rated power input
No-load speed
Reduced starting current
Run-on Brake
Overload Protection
Weight according to EPTA-Procedure 01/2003
Protection class
Dimensions (incl. removable product features)
Width x depth x height
Maximum workpiece dimensions, see page 37.
The values given are valid for a nominal voltage [U] of 230 V. For different voltages and models for specific countries, these values can vary.
Dimension of suitable saw blades
Saw blade diameter
Blade body thickness
Tooth thickness/setting, min.
Mounting hole diameter
Assembly
 Avoid unintentional starting of the machine. During as-
sembly and for all work on the machine, the power plug
must not be connected to the mains supply.
Delivery Scope
Please also observe the representation of the
delivery scope at the beginning of the operat-
ing instructions.
Before starting the operation of the machine
for the first time, check if all parts listed below have been sup-
plied:
– Table saw with mounted saw blade 32 and riving knife 7
– Angle stop 3
– Profile rail 34
– Fastening kit "profile rail" 52
(guide plate, knurled nut, screw, washer)
– Parallel guide 8
– Auxiliary parallel guide 49
– "Auxiliary parallel guide" fastening kit 39
(3 fastening screws, 3 washers, 3 wing nuts)
– Blade guard 5.x*
* depending on country version: 5.1/5.2
– Table extension 10
– Fastening kit for "table extension"43
(2 fastening screws, 2 washers, 1 open-end spanner)
– Hex key 37
– Ring spanner 15
Bosch Power Tools
W
-1
min
kg
mm 775 x 768 x 343
– Cover of the saw blade storage 14
– Push stick 13
mm 254
– Insert plate 31
mm 1.8
Note: Check the power tool for possible damage.
mm 2.6
Before further use of the machine, check that all protective
devices are fully functional. Any lightly damaged parts must
mm 30
be carefully checked to ensure flawless operation of the tool.
All parts must be properly mounted and all conditions fulfilled
that ensure faultless operation.
Damaged protective devices and parts must be immediately
replaced by an authorised service centre.
Mounting Individual Components
– Carefully remove all parts included in the delivery from
their packaging.
– Remove all packaging material from the machine and the
accessories provided.
– Open the bottom plate 44 and remove the packaging ma-
terial under the motor block. (see figure a)
The following product features are fastened directly to the
housing:
Push stick 13, ring spanner 15, Allen key 37, parallel guide 8,
angle guide 3, extraction adapter 41, auxiliary parallel guide
49 with fastening kit 39, blade guard 5.x.
– Carefully remove these product features from their stor-
age locations.
Also see figures R1–R6.
Additionally required tools (not in delivery scope):
– Slotted screwdriver
– Cross-head screwdriver
– Angle gauge
3 601 L30 400
3 601 L30 440
3 601 L30 470
3 601 L30 490
3 601 L30 4P0
3 601 L30 4R0 3 601 L30 460
2100
3200



35
/II
775 x 768 x 343
English | 33
GTS 10 XC
3 601 L30 430
1650 2000
4200 4200
 
 
 
35 35
/II /II
775 x 768 x 343
1 609 92A 15S | (29.1.15)