Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
15
14
16
11
12
20
1
7
2
15
19
14
19A
8
16
23
22
24
21
13
27
12
13
8
86452440 Manual Ranger 12 120V 60Hz
Connecting and Operating Elements
11. Zipper
12. Sliders
13. Connecting device
14. Handle tube
15. Handle
16. Handle guide (two parts that snap together)
17. Lower Bearing guide
18. Rotating cable hook
20. On / Off-Switch
21. Height adjustment Brush
22. Bearing block right hand
23. Release button bearing block
24. Foot pedal
25. Filter bag connection
26. Brush roller
27. Mains Connector
Please Note: The dust bag housing cover cannot be
removed completely!
illustrations only to improve clarity!
Assembly
Place the filter compartment (1) on the power head
(2) so that the connecting piece (13) reaches into the
corresponding opening. Open the zipper (11) of the
filter compartment by moving the two sliders (12) all
the way down to the right and to the left. Make sure
that both ends of the zipper reach straight into the
plastic part. They may not be folded or protrude.
Then press the bottom plate of the filter housing with
the flat of your hand and shake it lightly. For the final
connection of the main assemblies, one of the M5x30
screws (7) from the screw bag (6) is used. It should
now be easy to push it a few millimeters into the hole
and then engage with the thread inserted from the
back.
Insert the handle tube (14) into the grip (15), so that
the drilling (19A) in tube becomes visible through the
hole (19) in the handle (15). Secure this connection
with the M4x10 screw (8) out of the screw kit (6).
Additional tasks have to be performed for power cord
cable installation. Please refer to next page for details
of cable installation and routing.
It has been omitted in the
Publicidad
