Kärcher T 9/1 Bp Manual De Instrucciones página 13

Transport
CAUTION
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Storage
CAUTION
Risk of injury and damage! Note the weight
of the appliance in case of storage.
 Press the unlocking key and remove
the battery to avoid discharge.
This appliance must only be stored in inte-
rior rooms.
Care and maintenance
DANGER
Turn the appliance off and remove the bat-
tery before carrying out any tasks on the
machine.
Clean main filter basket
 Main filter basket (washable), clean it
under running water if necessary.
ATTENTION
Risk of damage! Never insert the main filter
basket while wet.
Replace motor protection filter
 Release and remove the suction head.
 Remove the motor protection filter.
 Insert new motor protection filter.
 Insert and lock the suction head.
Troubleshooting
DANGER
Turn the appliance off and remove the bat-
tery before carrying out any tasks on the
machine.
The appliance shuts off during the
– Motor thermal protector has responded.
 Replace the fleece filter bag or paper fil-
ter bag (option).
 Replace motor protection filter.
 Check all parts for plugging.
Switching back on after the motor turbine
has cooled off, after approx. 60 minutes.
Suction capacity decreases
 Remove choking of suction nozzle, suc-
tion tube or suction hose.
 Replace the fleece filter bag or paper fil-
ter bag (option).
 Clean the main filter basket under run-
ning water and dry it.
 Insert/lock the suction head correctly.
 Replace defective suction hose.
 Replace motor protection filter.
Dust comes out while vacuuming
 Replace the fleece filter bag or paper fil-
ter bag (option).
 Check the fleece filter bag or paper filter
bag (option).
 Insert/lock the suction head correctly.
 Insert undamaged main filter basket.
 Reinsert motor protection filter correct-
ly.
Appliance is not running
 Turn on the appliance.
– PCB overheated
Note: The appliance can be operated in
battery mode after the PCB has cooled
down.
– Battery empty
 Charge the battery.
– No battery is inserted
 Insert the battery.
– 4
EN
operation
13