Siemens 6ES7134-7SD00-0AB0 Informacion De Producto página 12

Εnglish A5E41143699-AB
Assembly
• Check the electronic submodule is not damaged.
Only connect undamaged electronic submodules to the
terminal module.
• The first time that an electronic submodule is inserted, the
coding elements on the terminal submodule will snap in
which prevents the insertion of the incorrect submodule.
This mechanical coding may not be changed.
• In Zone 1 and Zone 2, the electronic submodules may be
inserted and removed during operation. The enclosure
(Ex e / IP 54) in which the ET 200iSP is found may only be
opened briefly for this purpose (see the manual
"SIMATIC ET 200iSP Distributed I/O").
• In configuring the ET 200iSP, you must consider the
permissible number of electronic submodules (see the
manual "SIMATIC ET 200iSP Distributed I/O" section 3.6).
Commissioning
• The relevant national regulations must be observed when
commissioning the system.
• When checking the functionality of the equipment, observe
the EN 60 079-17 guidelines. This standard includes the
regulations found in the international standard
IEC 60 079-17.
For use in the USA or Canada
The control drawing for the ET 200iSP system is provided
with the Power Supply module. Alternatively, you may find the
latest edition at
http://www.siemens.com/automation/service&support
with the reference A5E00455287.
Εnglish