Cembre B500-TFC Manual De Uso Y Mantenimiento página 7

Do not use the tool for purposes other than those intended by Cembre.
The operator should concentrate on the work being performed and be carreful to maintain a
balanced working position.
Work in a clean, uncluttered area. Keep persons away from immediate work area.
Inspect the blade before each use. Do not use damaged blades as they may break and cause injury
or damage to the tool.
Before each use, verify the integrity of the tool; replace any worn, possibly damaged or missing
parts with original Cembre spares.
Wear eye protection. Metal chips can fl y from blades when cutting.
The tool is unsuitable for continuous use and should be allowed to cool down following uninter-
rupted, successive cutting operations; for instance, having exhausted a fully charged battery in
one session, delay battery replacement for a few minutes.
Protect the tool from rain and moisture. Water will damage the tool and battery. Electro-hydraulic
tools should not be operated in pouring rain.
The part reference includes the following:
Hydraulic cutting tool.
Li-Ion rechargeable battery (2 pcs).
Battery charger (model depends on the tool version).
Shoulder strap.
Carrying case.
USB cable (Ref. to § 5).
2. INSTRUCTIONS FOR USE
The tool can be easily carried using either the handle
or the shoulder strap attached to ring (12) (Ref. to Fig. 6).
Before starting any work, check the battery charge (Ref. to § 2.9) and recharge if necessary,
following the instructions in the battery charger user manual.
To
replace the battery, remove it by pressing the release button (11), then insert the new battery,
sliding it into the guides until it locks.
2.1) Head rotation
For ease of operation, the tool head can rotate, allowing the operator to work in the most comfort-
able position.
Do not attempt to rotate the head when the hydraulic circuit is pressurised.
7
WARNING
11