Thorough Cleaning - Cembre B500-TFC Manual De Uso Y Mantenimiento

2.8) Blade retraction
By operating the pressure release button (7), the ram will retract and open the blade.
2.9) Battery status
The battery is equipped with LED indicators that indicate the
remaining battery life at any time by pressing the adjacent but-
ton (10):
4 LEDs illuminated: fully charged
2 LEDs illuminated: 50 % capacity
1 LED flashing: minimum charge, replace the battery.
Worklights (1) illuminated combined with an alarm audible when the operating button (6)
is pressed, indicate that the battery voltage has dropped below a minimum safety threshold;
under these conditions the tool will not start, and it is necessary to recharge or replace the
battery.
The approximate time to fully recharge a battery is about 80 minutes.
After each working cycle, and after the extraction of the battery from the tool, an integrated
battery cut-off device will operate after 70 s approx. Then the LED nearest to button (10)
will fl ash 5 times each 14 s approx. The battery will be reactivated when it is reintroduced
into the tool and the operating button is pressed.
2.10) Using the battery charger
Carefully follow the instructions in the battery charger user manual.
3. MAINTENANCE
The tool is robust, and requires very little daily maintenance. Compliance with the following points,
should help to maintain its optimum performance:

3.1) Thorough cleaning

Dust, sand and dirt are a danger for any hydraulic device. Every day, after use, the tool must be wiped
with a clean cloth taking care to remove any residue, especially close to pivots and moveable parts.
Do not use hydrocarbons to clean the rubber parts.
Regularly lubricate the moving parts and pivot pins of the head with a few drops of oil.
3.2) Storage case
When not in use, the tool should be stored and transported in the steel case, to prevent damage.
The case, type VAL-TFC, is suitable for storing the tool and accessories.
VAL-TFC: Size 559x459x131 mm (22x18.1x5.2 inches). Weight 7,8 kg (17.2 lbs).
9
10