Worx WT542 Manual De Instrucciones página 11

processed dependant on the following examples and
other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well
maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately
managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off and
when it is running idle but not actually doing the job. This
may significantly reduce the exposure level over the total
working period.
Helping to minimise your vibration and noise
exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high
vibration tool use across a number of days.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE
The machine is intended for sawing wood, plastic, metal and
building materials while resting firmly on the workpiece.
It is suitable for straight and curved cuts. The saw blade
recommendations are to be observed.
ASSEMBLY AND OPERATION
ACTION
BEFORE OPERATION
Removing the battery pack
Charging the battery
Installing the battery pack
ASSEMBLY
Cordless Jigsaw
Blade Installation
NOTE: Ensure the blade is installed in
place. The black line on the blade needs
to be totally inserted into the tool-free
blade holder.
Blade Removal
NOTE: Hold the blade with one hand
when remove the blade.
Vacuum Adapter Installation
Vacuum Adapter Removal
NOTE: Press and hold the projection
on the bottom of the vacuum adapter
before pulling it out of the machine.
OPERATION
Pendulum Function
Safety On/Off Switch
NOTE: For safety reasons the On/Off
switch of the machine cannot be locked;
it must remain pressed during the entire
operation.
Increasing or reducing the pressure
on the On/Off switch enables stepless
stroke-rate control of the switched-on
machine.
Straight Cut and Curve Cut
Bevel Cut
NOTE: Remove the vacuum adapter
before adjust the base plate.
NOTE: Rotate the base plate to the
desired position according to the scale.
Ensure the blade is engaged between
the blade positioning wheel .
Plunge Cut
WORKING HINTS FOR YOUR
JIGSAW
If your power tool becomes too hot, please run your jigsaw
no load for 2-3 minutes to cool the motor. Avoid prolonged
FIGURE
usage at very low speeds.
Always use a blade suited to the material and material
thickness to be cut. For tight curves it is best to use a
narrow saw blade. When sawing metal or similar materials,
apply coolant/lubricant alongside the cutting line.
See Fig. A1
Always ensure the workpiece is firmly held or clamped
to prevent movement. Any movement of the material
See Fig. A2
may affect the quality of the cut. The blade cuts on the
See Fig. A3 upward stroke and may chip the uppermost. Ensure your
uppermost surface is a non-visible surface when your work
is finished.
For easier control, use low speed to start cutting and then
See Fig. B1
See Fig. B2
See Fig. B3
See Fig. B4
See Fig. C
See Fig. D
11
See Fig.
E1, E2
See Fig. F, G
See Fig. H
EN