Worx WT542 Manual De Instrucciones página 12

increase to correct speed.
In order to avoid operation malfunctions, do not saw
gypsum board from below or overhead.
The guide roller should occasionally be checked for wear
and lubricated with a drop of oil. If it is worn, it must be
replaced.
MAINTENANCE
Remove the battery pack from the tool before carrying out
any adjustment, servicing or maintenance.
There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your power
tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust. Occasionally you
may see sparks through the ventilation slots. This is
normal and will not damage your power tool.
FOR BATTERY TOOLS
The ambient temperature range for the use and storage of
tool and battery is 0℃-45℃.
The recommended ambient temperature range for the
charging system during charging is 0℃-40℃.
TROUBLESHOOTING
12 12
Possible
Symptom
Causes
Overload
Battery
temperature
The tool
too high
suddenly
stops
during
operation.
Low battery
capacity
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be disposed of
with household waste. Please recycle where
facilities exist. Check with your
authorities or retailer for recycling advice.
Cordless Jigsaw
Possible Solution
Relieve the load on the
machine immediately
and allow cooling for
approx. 30 seconds by
running the machine on
no-load.
Charge the battery
pack.
local
DECLARATION OF
CONFORMITY
We,
POSITEC Germany GmbH
Grüner Weg 10, 50825 Cologne, Germany
Declare that the product,
Description Worx Cordless Jigsaw
Type Designation WT542 WT542.9 (5 - designation of
machinery, representative of Jig Saw)
Function Sawing various materials
Complies with the following directives,
2006/42/EC,
2014/30/EU,
2011/65/EU&(EU)2015/863
Standards conform to
EN 62841-1,
EN 62841-2-11,
EN 55014-1,
EN 55014-2
The person authorized to compile the technical file,
Name Marcel Filz
Address Positec Germany GmbH Grüner Weg 10,
50825 Cologne, Germany
2020/08/27
Allen Ding
Deputy Chief Engineer, Testing & Certification
Positec Technology (China) Co., Ltd
18, Dongwang Road, Suzhou Industrial
Park, Jiangsu 215123, P. R. China
EN