Joie gemm Manual De Instrucciones página 14

Use with Strollers
see images -
35 44
Your infant child restraint is designed to attach to certain Joie
stroller models featuring a special tray, armbar or calf support.
!
Please make sure your stroller can fit the infant child
restraint before purchasing it.
!
Never allow more than one baby in the travel system at
one time.
!
Please brake your stroller before assembling the infant
child restraint.
!
Check that the parts used to fix the infant child restraint
are securely fastened on the stroller.
!
Recline the stroller seat back to the lowest position.
Use with Joie Strollers
To assemble the infant child restraint on Joie strollers, please
follow these steps:
1. Place child restraint into stroller so notches in rockers fit over
edge of armbar, tray or calf support. The child restraint will
then automatically click into place.
!
If armbar has fabric cover, please detach the Velcro on
armbar cover first.
37
!
For the stroller with a special calf support, please adjust
the calf support to the vertical position, detach the
Velcro, and then lift the fabric cover.
2. Use the straps on both sides of stroller to fix the child
restraint. & &
39 40 41
!
Try pulling the child restraint upwards to check that it is
fitted correctly.
13
& & &
35 36 37 38
-1
-1
38
To remove the child restraint, release the straps from the child
restraint, pull up the stroller release handle to release the child
restraint from tray, armbar or calf support, and then lift child
restraint out of stroller. Please refer to
Detaching Hood and
Seat Pad
see images -
45 49
To detach the hood, while pressing the button in the hood
mount, pull the hood bow out.
To detach the seat pad, you should refer to the following steps:
1. You must remove the insert first. To do this simply unlock
the buckle, then unclip the snaps on both sides of the insert
and pull out away from the seat.
2. To remove the crotch pad, first locate the elastic on the
inside of the crotch pad. Pull both the elastic and the crotch
pad over the buckle to remove.
3. You must remove the shoulder harnesses and shoulder
pads. To do this please refer to the section 'Shoulder Harness
Strap Height Adjustment'.
4. Pull out the fastening pieces underneath the edge of the
seat.
47
5. Detach the metal hook from the edge of the child restraint,
and then lift it up to seperate the seat pad from the stroller fix
release button A.
48
6. Detach the seat pad from around the adjustment button as
shown in
49
To refit the seat pad simply reverse the steps above, however
make sure that the shoulder harnesses are not crossed over
and not twisted.
& & .
42 43 44
45
46
14