Selco RI2000 Instrucciones De Uso página 29

1 WARNING
Prior to performing any operation on the machine, make sure that you have thoroughly read and understood the
contents of this manual. Do not perform modifications or maintenance operations which are not prescribed.
The electrical system must be made by skilled technicians with the specific professional and technical qualifica-
tions and in compliance with the regulations in force in the country where the equipment is installed.
Disconnect the power supply before every operation!
2 INSTALLATION
The RI2000 robot interface is a device enabling communication between a Selco generator and an automated or robotised sys-
tem.
The device is able to communicate via analog and/or digital signals, in both reception and transmission. The information is trans-
ferred to the welding generator via a specific connection cable with CAN BUS protocol.
In this manual, the signals entering the robot interface will be referred to as "INPUTS", whereas the signals coming out of the robot
interface will be referred to as "OUTPUTS".
ANALOG OR DIGITAL
INPUTS
ANALOG OR DIGITAL
OUTPUTS
29