Makita LS1017 Manual De Instrucciones página 10

Storage of socket wrench with hex wrench on
its other end
011338
The socket wrench is stored as shown in the figure.
When the socket wrench is needed it can be pulled out of
the wrench holder. After using the socket wrench it can
be stored by returning it to the wrench holder.
Installing or removing saw blade
WARNING:
Always be sure that the tool is switched off and
•
unplugged before installing or removing the
blade. Accidental start up of the tool may result in
serious personal injury.
Use only the Makita socket wrench provided to
•
install or remove the blade.Failure to use the
wrench may result in overtightening or insufficient
tightening of the hex bolt and serious personal
injury.
1
010228
Lock the handle in the raised position by pushing in the
stopper pin.
1
010390
To remove the blade, use the socket wrench to loosen
the hex bolt holding the center cover by turning it
counterclockwise. Raise the blade guard and center
cover.
1. Socket wrench
2
with hex wrench
on its other end
2. Wrench holder
1
1. Stopper pin
2
1. Socket wrench
2. Blade case
3. Center cover
3
4. Hex bolt
5. Blade guard
5
4
1
2
010391
Press the shaft lock to lock the spindle and use the
socket wrench to loosen the hex bolt clockwise. Then
remove the hex bolt, outer flange and blade.
NOTE:
If the inner flange is removed be sure to install it on
•
the spindle with its protrusion facing away from the
blade. If the flange is installed incorrectly the
flange will rub against the machine.
WARNING:
Before mounting the blade onto the spindle,
•
always be sure that the correct ring for the
blade's arbor hole you intend to use is installed
between the inner and the outer flanges. Use of
the incorrect arbor hole ring
improper mounting of the blade causing blade
movement and severe vibration resulting in
possible loss of control during operation and in
serious personal injury.
1
010392
1 2
001786
To install the blade, mount it carefully onto the spindle,
making sure that the direction of the arrow on the surface
of the blade matches the direction of the arrow on the
blade case.
Install the outer flange and hex bolt, and then use the
socket wrench to tighten the hex bolt (left-handed)
10
1. Blade case
2. Socket wrench
3. Hex bolt
4. Arrow
5. Shaft lock
5
4
3
may result in the
1. Blade case
2
3
2. Arrow
3. Arrow
4. Saw blade
4
1. Hex bolt
4 5
2. Outer flange
3. Saw blade
4. Inner flange
5. Spindle
3