Toshiba MML-UP0071BH-UL Manual De Instalación página 5

4
Installation
CAUTION
Strictly comply with the following rules to prevent damage of the indoor units and human injury.
• Do not put a heavy article on the indoor unit or let a person get on it. (Even units are packaged)
• Carry in the indoor unit as it is packaged if possible. If it is necessary to carry the indoor unit unpacked, then use
buffering cloth or other material so as to not damage the unit.
• To move the indoor unit, hold the bottom face of the unit only.
Do not apply force to the other parts (refrigerant pipe, drain pan, foamed parts, resin parts or other parts).
• Have two or more people carry the package, and do not bundle it with plastic band at positions other than specified.
• Protective polystyrene foams for transportation are attached to the underneath of the side plates on both sides of the
unit. Remove them before installation of the unit.
• Install the indoor unit before putting up wall.
7-EN
 Installation of indoor unit
1
Remove foamed polystylene cushion for
protection during transportation, which is
entered under left / right side plate of the
main unit and electrical control box.
Also, before installing the unit, remove tape for
transportation adhered to the electrical control
box.
2
Install the indoor unit before lining the wall.
Electrical
control box
Tape for
transportation
Foamed polystylene cushion
(Both left and right)
 Fixing of unit
Fix the indoor unit to the floor and wall by attaching two
or four M8 anchor bolts to the position in the following
figure to tighten and fix with nut utilizing holes at left /
right side plates.
Fixing indoor unit to floor
<Indoor unit viewed from overhead>
(Front side)
A
B
Model MML- A
UP007 to UP012 22.8 580)
" (
UP015 to UP024 34.6 880)
" (
* Attach and fix the electrical control box to the wall
under condition that electrical control box to be
attached to the side face is removed. Remove the
electrical control box as follows.
– 4 –
Fixing indoor unit to wall
<Indoor unit viewed from front side>
(Floor)
A
B
Model MML- A
UP007 to UP012 22.8 " ( 580)
UP015 to UP024 34.6 " ( 880)
Unit: in (mm)
B
24.0 610)
" (
35.8 910)
" (
Unit: in (mm)
Hole is provided to
rear side.
B
24.0 " ( 610)
35.8 " ( 910)
EN
8-EN