2.
will release. The pulse symbol (
with systolic and diastolic pressure.
3. An icon will appear in the LCD Display to indicate
whether you were sufficiently rested during the
measurement (
= Rested,
the „Resting Indicator" subsection below for details.
4. Er_ (where the blank space
is a number 1-8) will appear
if the measurement was not
performed properly. Refer to the
„Troubleshooting Guide" section
for details about specific error
message numbers and then
repeat the measurement.
5. To select a desired user memory, press the M1 or M2
Button. Each of the two user memories can store 120
sets of measurements. If you do not select a user
memory, the measurement will be stored in the most
recently-used user memory.
) will display, along
= Not rested). See
14
6. If Bluetooth
data transfer is active, the unit will transmit
®
measurement data to the "beurer HealthManager
Pro" mobile app installed on your paired mobile
device. The Bluetooth
establishes communication with your mobile device
and will display when a link is successful. After data
unsuccessful, the error message "
Also, if the unit cannot establish a Bluetooth
NOTE: Remember that you must add the SERIES 800W
blood pressure monitor to the "beurer HealthManager
Pro" app to enable data transfer.
7. Press the START/STOP
pressure monitor if needed. The measurement is stored
in the selected user memory. The device will also shut
8. Wait at least five minutes before taking another
measurement.
icon will flash while the unit
®
" will display.
®