YATO YT-82187 Manual De Instrucciones página 13

PRODUCT OVERVIEW
The band saw is a handheld power tool, which, by means of a saw blade formed into an endless loop, can cut pipes, tubes, and
other metal sections. The saw has a battery power supply which allows working in places without access to electricity. Proper,
reliable, and safe operation of the product depends on its appropriate use; that is why you should:
Read the entire instructions manual before the fi rst use of the tool and keep it for future reference.
The supplier shall not be liable for any damage resulting from failure to comply with the safety instructions and recommendations
specifi ed in this instructions manual.
PRODUCT ACCESSORIES
The tool is delivered complete but requires preparation for operation. A saw blade is supplied with the product. The YT-82187
article is equipped with a battery and a dedicated charger. The YT-82188 article is not supplied with a battery and charger.
TECHNICAL DATA
Parameter
Catalogue No.
Rated voltage
Saw blade speed
Saw blade specifi cations
- length
- height
- thickness
- number of teeth per inch of blade length (TPI)
Cutting range (H x W)
Weight
Insulation class
Protection rating
Noise level
- sound pressure, LpA ± K
- sound power, LwA ± K
Vibration level, ah ± K (metal/wood cutting)
Battery type
Battery capacity*
Charger*
Input voltage
Mains frequency
Output voltage
Output current
Rated power
Charging time**
* only for models equipped with a battery and charger
** the specifi ed charging time applies only to the battery with the capacity listed in the table
The declared noise emission value has been measured using the standard test method and can be used to compare one tool to
another. The declared noise emission value can be used in the preliminary exposure assessment.
The declared total vibration value has been measured using the standard test method and can be used to compare one tool to
another. The declared total vibration value can be used in the initial exposure assessment.
Caution! The vibration emission during tool operation may diff er from the declared value, depending on the manner the tool is used.
Caution! Safety measures to protect the operator, which are based on an assessment of exposure under actual conditions of
use (including all parts of the work cycle, such as the time when the tool is switched off or idle and the activation time), must be
specifi ed.
O R I G I N A L
EN
Unit
[V DC]
[m/min]
[mm]
[mm]
[mm]
-
[mm]
[kg]
-
-
[dB(A)]
[dB(A)]
[m/s ]
2
[Ah]
[V~]
[Hz]
[V DC]
[A]
[W]
[h]
I N S T R U C T I O N S
Value
YT-82187, YT-82188
18
0 - 120
1140
12.7
0.6
14
127 x 127
6.3
II
IP20
82.0 ± 3.0
93.0 ± 3.0
5.14 ± 1.5 / 4.65 ± 1.5
Li-ion
4
220 - 240
50 / 60
21
2
60
3
13