GreenWorks G20 Manual Del Operador página 7

EN
Do not operate without the water supply connected.
Before you start the machine:
1. Turn the water supply on.
2. Pull the gun trigger to release air pressure.
3. If a stable stream of water comes out from the gun,
release the gun trigger.
1. Connect the machine to the power supply.
2. Set the power switch to the "ON" ( | ) position.
3. Turn the water supply on.
4. Pull the gun trigger.
4.6 STOP THE MACHINE
1. Release the gun trigger.
2. Set the power switch to the "OFF" (O) position.
If you do not use the machine：
• Stop the machine.
• Turn the water supply off.
• Disconnect the power cord from the outlet.
• Pull the gun trigger to release the remaining
pressure from the machine.
• Lock the trigger safety button.
5 MAINTENANCE
Before maintenance, make sure that you
• stop the machine.
• wait until all the moving parts stop.
• disconnect the plug from the power source.
Do not use strong solvents or detergents on the plastic
housing or components.
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can
cause damage to the plastic, and make the plastic
unserviceable.
Replace the power cord by an approved service
center.
CAUTION
CAUTION
WARNING
WARNING
WARNING
WARNING
WARNING
English
5.1 NOZZLE MAINTENANCE
Figure 6.
If there is too much pump pressure, the nozzle can
become clogged, you can feel a pulsing sensation while
you pull the gun trigger.
5.1.1 REMOVE THE NOZZLE
1. Push and hold the lock button on the spray wand.
2. Remove the nozzle from the spary wand.
5.1.2 CLEAN THE NOZZLE
1. Use a straight paper clip or cleaning tool to clean
the spray tip.
2. Flush and clean the unwanted materials out of the
nozzle with the garden hose.
3. Install the clean nozzle to the spray wand.
6 TRANSPORTATION AND
STORAGE
Disconnect the power cord before transportation and
storage.
6.1 MOVE THE MACHINE
• Point the spray wand in a safe direction.
• Only hold the machine with the handgrip.
6.2 STORE THE MACHINE
Make sure that the gun, the high pressure hose and
the pump are dry.
Make sure that children cannot come near the
machine.
Use a recommended pump protector to prevent cold
weather damage during storage in winter.
• Disconnect the garden hose from machine.
• Wind the high pressure hose.
• Clean housing and the plastic components with a
moist and soft cloth.
• Make sure that the machine does not have loose
or damaged parts. If it is necessary, do these steps/
instructions:
• replace the damaged parts.
• tighten the bolts.
• speak to a person of an approved service center.
6
WARNING
WARNING
WARNING
NOTE