IKEA VAPPEBY Manual De Instrucciones página 10

To remove previously made Bluetooth pairings, reset the speaker
by pressing and holding the volume knob for more than 5 sec.
Successful factory reset is confirmed by red LED flashing and
sound feedback.
Alternatively, go to the Bluetooth menu on your source device and
un-pair.
Good to know
• The speaker is protected against dust and water according to
IP54.
• Devices may get warm during charging; this is completely normal
and they will gradually cool down again after they are fully
charged.
• Charging time may vary based on the device's battery capacity,
charge level, the age of the battery and the temperature in the
surrounding area.
• Storage temperature: -20°C to 25°C (-4°F to 77°F).
• Unplug the product from the power supply before cleaning and
when it is not in use.
• It is normal for the battery to become hot during charging and it
will gradually cool down after charging.
• Battery should not be left discharged for a longer period.
• Battery should not be charged while in contact with flammable
material like textiles.
WARNING:
• Too high volume can damage your hearing
• Only use the included 24V adapter for charging.
• Do not charge product when wet.
• Only charge the product indoors.
• Do not use a defective power supply when charging the product.
• Never install the product in a confined space.
• Always leave a space of at least 5 mm around the product for
ventilation.
• Children should be supervised to ensure they do not misuse
the product.
• Do not modify, disassemble, open, drop, crush, puncture, or
shred battery.
• Do not expose the battery to rain or water.
• Risk of fires and burns. Do not open, crush, heat above 60 °C
(140 °F), or incinerate.
10