Publicidad
Idiomas disponibles
Idiomas disponibles
Exhaust Hose Installation
In this stage, you will need...
•
Assembled heat exhaust hose
•
Pro Breeze smart portable air conditioner
1.
Clip the exhaust hose into the rear panel outlet situated on the back of your air conditioner.
Ensure it is tightly secured in place
2.
When in Cooling Mode, position your air conditioner close to a window or door, with the hose
outside, to allow the unit to vent the warm air out of the room
Sliding Windows Sealing Board Assembly Installation
You will need:
•
Window sealing board kit (Panel A&B + Clip)
•
Finished heat exhaust hose short connector
1.
Insert Panel B into Panel A and adjust to the length or
height of the window (see images)
2.
Open your window and place the sealing board assembly
into the open space.
3.
Adjust to ensure an exact fit and secure with the clip.
4.
Close the window to lock everything into place.
5.
Attach the heat exhaust hose short connector to the
elliptical hole.
The sealing board assembly is now ready for use.
Notes:
•
If your window opening is smaller than the minimum
length of the sealing board assembly trim to desired
length using a hack saw.
•
If your window opening is larger than the maximum length
of the sealing board assembly use plywood or similar to fill
the gap.
Scan for Full Video Instructions on How Best to Fit Your Hinged
Door and Window Seals
Hinged Window Sealing Fabric Assembly Installation
If your window is hinged, follow the instructions below:
You will need:
14 of 76 | English
•
Hinged window fabric sealing assembly
•
Sealing velcro
•
A soft, clean cloth
1.
Open window and clean frame and
casement surfaces of dust and particles.
2.
Stick the velcro tape around the entire
window frame. Never stick to the window seal
as doing so will prohibit the window from
closing fully.
3.
Stick the velcro tape around the entire
window casement (inside or outside). Check
to ensure the window can close fully.
4.
Attach side A of the sealing fabric assembly
to the velcro on the window frame working
from the centre outwards.
5.
Close and open window to ensure no fabric
gets trapped.
6.
Attach side B of the sealing fabric assembly
to the velcro on the window casement
working from the centre outwards.
7.
Open the window slightly and insert the heat
exhaust hose short connector into the sealing
fabric assembly securing with the zippers
around its lip.
The sealing fabric assembly is now ready for use.
OPERATING INSTRUCTIONS
― ―
•
Power button: Press once to turn your device
ON/OFF
•
Fan speed button: Press to choose between
high and low speed.
Note: you cannot change the fan speed in dry
mode
•
Up And Down Buttons
Use the up and down buttons to:
1.
Set desired temperature when in cooling mode.
2.
Set desired hours until turn-on and turn-off when setting a timer.
3.
Change between °C and °F by pressing both down at the same time.
•
Mode button: Press this button to change to one of the four modes outlined below. The
relevant indicator will illuminate when the mode has been selected.
English | 15 of 76
Publicidad
