Kärcher SC 3 EasyFix Manual De Instrucciones página 15

Safety devices
CAUTION
Missing or modified safety devices
Safety devices are provided for your own protection.
Never modify or bypass safety devices.
Symbols on the device
(according to type of appliance)
Risk of burns, surface of appliance be-
comes hot during operation
Risk of scalding from steam
Read operating instructions
Description of the unit
The maximum amount of equipment is described in
these operating instructions. Depending on the model
used, there are differences in the scope of delivery (see
packaging).
For the illustrations, refer to the graphics page.
Illustration A
Decalcification cartridge
1
Filling hole for water
2
Carrying handle
3
Holder for accessories
4
Display
5
Indicator light (green) - mains voltage present
6
Indicator light (red) - water shortage
7
Indicator light (red) - replace decalcification car-
8
tridge.
RESET button - set water hardness.
9
Switch - On
10
Switch - Off
11
Park bracket for floor nozzle
12
Mains connection cable with mains plug
13
Non-driven wheels (2 x)
14
Steering roller
15
Steam gun
16
Steam lever
17
Unlocking button
18
Selector switch for steam volume (child lock)
19
Steam hose
20
Spotlight nozzle
21
Round brush (small, black)
22
** Round brush (small, yellow)
23
** Power nozzle
24
** Round brush (large)
25
Manual nozzle
26
Microfibre cover for manual nozzle
27
Extension tubes (2 x)
28
Unlocking button
29
Floor nozzle
30
Hook and loop fastener
31
Microfibre floor cloth (1 x)
32
** Microfibre floor cloth (2 x)
33
** Carpet glider
34
** optional
ATTENTION
Device damage due to calcification
The decalcification cartridge only works properly if you
adjust the device to the local water hardness before op-
erating it for the first time.
Set the device to the local water hardness.
Set the device to the current water hardness before us-
ing it in an area with a different water hardness (e.g. af-
ter a move)
1. Insert the decalcification cartridge into the opening
and push it so that it is firmly in place.
Illustration C
2. Set the water hardness, see chapter Setting the wa-
ter hardness.
Installing accessories
1. Insert and engage the steering roller and non-driven
wheels.
Illustration B
2. Push the open end of the accessory onto the steam
gun so that the unlocking button on the steam gun
engages.
Illustration H
3. Push the open end of the accessory onto the spot-
light nozzle.
Illustration I
4. Connect the extension tubes with the steam gun.
a Push the 1st Push the first extension tube onto
the steam gun so that the unlocking button on the
steam gun engages.
The connection pipe is connected.
b Push the 2nd extension tube onto the
1st extension tube.
The connection pipes are connected.
Illustration J
5. Push the accessory and / or the floor nozzle onto the
free end of the extension tube.
Illustration K
The accessory is connected.
Disconnecting accessories
1. Set the selector switch for the steam volume to the
rear.
The steam lever is locked.
2. Push the unlocking button and pull the parts apart.
Illustration N
English
Initial start-up
Installation
15