Publicidad
Idiomas disponibles
Idiomas disponibles
English
Code Table
Errors
Phenomena
Code
Sound
No cooker
E1
Give out two long and three
Low voltage
E2
short beep prompts every 5
seconds
Overvoltage
Give out two long and four
E3
short beep prompts every 5
seconds
IGBT
Give out four long and three
E0
Over-temperature
short beep prompts every 5
seconds
NTC1
Give out four long and five
E7
is of open circuit
short beep prompts every 5
seconds
NTC1
Give out four long and four
E8
is of short circuit
short beep prompts every 5
seconds
NTC2
Give out three long and five
E9
is of open circuit
short beep prompts every 5
seconds
NTC2
Give out three long and four
Ee
is of short circuit
short beep prompts every 5
seconds
High temperature
H
attention
No safety mat
C
Operation Voltage:
Left Rear Burner Power
Left Front Burner Power
Left Bridge Zone Power
Right Rear Burner Power
Right Front Burner Power
Right Bridge Zone Power
Max. Power
26
INDULAP001
User Manual
Remarks
Change to the shutdown after about 60s
Until the voltage is restored
Change to the shutdown after sounding
twice
Until the fault is eliminated
Safety mat should be put in correct
position for cooktop operation
AC 220V - 240V, 50Hz/60Hz
max. 1600W
max. 2000W
max. 2800W
max. 2000W
max. 1600W
max. 2800W
7000W
User Manual
Troubleshooting list
Problem
Cause/Notes
The drawer fitted underneath the
When you use the hob, certain areas
induction hob gets very hot
of the drawer below may reach
temperatures of up to 60°C.
This is not a malfunction.
My hob won't turn on
Possible problem with the electricity
supply.
The hob trips the residual current
Possible problem with the electricity
device of my home's electrical
supply or there may be a fault with the
system.
appliance
INDULAP001
English
Solution
1. Check that the induction hob has been
installed in compliance with the installation
instructions.
2. Do not keep flammable items in the drawer.
1. Check that the device is correctly connected
to the electricity supply. Make sure that it has
been installed correctly by calling an authorised
installation technician or a qualified electrician
in order to resolve the issue.
2. Make sure that the malfunction isn't being
caused by the fuse. Reset the circuit breaker/
RCD (residual current device) or replace the
fuse.
3. Contact an authorised assistance centre.
If the above suggestions do not resolve the issue,
we recommend that you request a visit from an
assistance technician.
1. Ensure that the residual current device is
sufficient for the power to be absorbed. Check
with a qualified electrician whether you are
using the right residual current device and
whether the hob is connected to a separate
group of fuses.
2. Make sure the device is properly connected
to the electricity supply. Check that it has been
installed properly by contacting an authorised
installation technician.
3. Contact an authorised assistance centre.
If the above suggestions do not resolve the issue,
we recommend that you book an appointment
with a qualified technician.
WARNING: We advise you not to use the
appliance until the problem has been completely
resolved. Unplug the appliance and do not
reconnect it until you are sure that it is safe to
do so.
27
Publicidad
