Publicidad
Idiomas disponibles
Idiomas disponibles
2. Reassemble the upper part with selec-
tor as shown in the assembly diagram
section C1.2.
Attention,
the
(C1.2.2) must fit in perfectly into the
upper part (C1.2.1). To do so, you must
align the arrow on the selector's sup-
port with the shaft coupling accesso-
ries, see the image.
3. Pour the medication prescribed by the
doctor into the lower part (C1.1).
Insert the upper part (C1.2) into the
lower part (C1.1), close the nebuliser by
turning the upper part (C1.2) clockwise.
4. Connect accessories as indicated in the "Connection diagram" on the cover.
5. Sit comfortably holding the nebuliser in your hand, place
the mouthpiece onto your mouth or alternatively use the
nose piece or mask. Should you opt for the mask acces-
sory, place it on your face as shown in the picture (with or
without using the elasticated strap).
6. Start the device by means of switch (A1) and breathe
deeply in and out. After inhaling, we recommend holding
your breath for an instant to allow the inhaled drops of
aerosol to deposit. Then exhale slowly.
7. Upon completing application, switch off the device and
unplug it.
ATTENTION: If after the therapy session an evident de-
posit of moisture forms within the pipe (B), detach the pipe from the nebuliser and
dry it with the very ventilation from the compressor; this operation prevents possible
blooms of mould inside the pipe.
USER METHODS OF THE "RF8 DUAL SPEED" NEBULISER WITH SPEED SELECTOR
To make the inhalation therapy faster, turn the speed selector
(C1.2.3) clockwise.
For more effective inhalation therapy, turn the speed selector
(C1.2.3) anticlockwise. In this case, you have optimal assumption
of the medication, minimising leaks into the surrounding environ-
ment.
selector's
support
11
C1.2.1
C1.2.2
Publicidad
