Viper AS380/15B-EU Manual Del Usuario página 6

1. Fill water into solution tank (3) from the inlet (20) through pipe or bucket
2. Do not fill the solution tank completely, leave a few centimeters from the edge.
3. The water temperature must not exceed 40
1 Unscrew the drain cap (22) on the bottom of solution tank. The solution/water will flow
．
freely into a bucket or floor drain.
2 Rinse the solution tank with clean water after every use. This will help prevent chemical
．
build up and clogging of the solution lines
3 Screw up the drain cap (22).
．
1 Turn the latch (17) off the recovery tank, take off the recovery tank from machine by
．
grasping two grooves of tank. Open the lid (1) and overturn the recovery tank to
drain the dirty water into a container, or unscrew the drain cap (22) to let water pipe
out to a bucket.
2 Clean and Rinse the recovery tank with clean water after every use.
．
3 Re-place the recovery tank on the machine and turn the latch (17) to lock the tank..
．
1 Set the handle to a comfortable height by pressing level (25).
．
2 Lower the squeegee (33) onto the floor by pulling down the lift mechanism (26).
．
.
℃
！