GB
4 Operating
4.1 Fitting the cuff
Attach the clean cuff to the left wrist which is
1.
free from clothing with the palm of the hand
facing upwards (fig.1).
2.
There should be a gap of approx. 1 cm between
the cuff and the palm of the hand (fig.2).
Press the Velcro tape firmly around the wrist
3.
ensuring that it is not so tight that it could falsify
the measured result (fig.3).
4.
Correct position for taking readings:
Carry out the measurement whilst seated.
Relax your arm and place it comfortably, on a
table for instance. Raise the wrist so that the cuff
of the monitor is at heart level (fig. 4, position a =
too high, b = correct, c = too low).
•
Relax during the measuring process:
do not move or talk, as this can affect
the results.
With repeated measurements, blood
•
accumulates in the arm which can
lead to false reading. Consecutive
blood pressure measurements should
be repeated after 3 minutes pause or
after the arm has been held up in
order to allow the accumulated blood
to flow away.
4.2 Taking a blood pressure measurement
After appropriate positioning of the cuff, the measurement can begin.
Before using the unit, you need to put the LOCK-switch
1.
"ON" (green). In "OFF" (red) - position the Bluetooth function is deacti-
vated and all buttons are locked.
Switch the unit on by pressing the START/STOP button
2.
3.
All display characters are shortly shown in the display. This test can be
used to check that the display is indicating properly and in full. The unit
is ready for measurement and the number 0 appears.
The device automatically inflates the cuff slowly in order to measure your
4.
blood pressure. The rising pressure in the cuff is shown on the display.
When the device detects the signal, the heart symbol on the display
5.
starts to flash.
6.
If a result is determined, the device slowly will release the air from the
cuff. The systolic and diastolic blood pressure and the pulse value with
the time value appear on the display.
24
1
approx. 1 cm
2
3
4
a
b
c
to position
.
i
i
i
i