Publicidad
Idiomas disponibles
Idiomas disponibles
BEFORE USING FOR THE FIRST TIME:
Wash the griddle with water and soap and dry. Put a coat of
vegetable oil and clean the excess with a paper towel.
Don't leave the griddle empty nearby the cooktop burners.
■
Don't preheat the griddle. Damage can happen to the
■
non-stick surface.
The griddle shouldn't be used to cook, grill or in the
■
microwave.
To avoid splashing fat when cooking, use moderate oil and
■
fat.
Don't cut meat or other food directly in the griddle, you could
■
damage the non-stick coating.
Avoid using metal utensils.
■
Oven Use
Cookware
For an even cooking, the hot air must be able to flow around the
food.
Leave a 5 cm space around the cookware and the oven walls.
Use this table as a reference:
Amount of
Location in the oven rack
cookware
1
Centered in the rack
2
Side by side or slightly in zigzag
3 or 4
In opposite corners of the rack.
Make sure any dish is directly over another
Oven Racks
Manual sliding
The oven has 5 different rack positions. There is a bump in the
oven rails that stop the rack from falling when they are slide out.
To change the position of the racks follow these steps:
1. Pull the oven rack out until the bump.
2. Lift the rack from the front.
3. Pull out again to release the rack.
4. Choose the new rack position.
5. Place the shelf and push it until the bump.
6. Lift the rack from the front.
7. Push the rack again until you can feel the back wall of the
oven with the rack.
10
A. Oven rack
B. Bump
Your range is equipped with an oven light (some models), this is a
very important feature that allows you to check the food without
opening the door.
The oven light turns on when the light button
next to the knob on the end (some models).
To turn off the light, press the button again, in model with full
oven control, oven control use (below section).
When the light bulb is blown, replace it as per below mentioned
steps:
1. Unplug the range cable or disconnect the power supply.
2. Remove the light bulb unscrew counterclockwise.
3. Replace with a new especial 40 W light bulb for appliances.
4. Reconnect the range or turn on the power supply.
Oven Control Use (Some Models)
B
C
A
L
K
J
A. Oven Light
B. Clock
C. Bake indicator light
D. Display
E. Timer indicator light
F. Start (control lock)
Display
When power is first supplied to the appliance, a flashing time will
appear on the display. Press OFF/CANCEL to clear flashing time
from the display.
If flashing time appears, a power failure has occurred.
Press OFF/CANCEL and reset the clock if needed.
When the oven is not in use, the display shows the time of day.
When performing a cook or timer function, the display will show
either hours and minutes and seconds.
Oven indicator light
The indicator light are located on both sides of the display. The
indicator lights light up or flash when the oven is one of the
following modes: Bake, Broil or Timer.
Start
Start begins any oven function. If Stars is not pressed within
5 seconds after pressing a function pad, the push to Start
("PSH") indicator light will flash and the push to start tone will
sound as a reminder.
If Start is not pressed within 1 minute after pressing a function
pad, the oven display will return to the time of day mode and the
programmed function will be canceled.
is pressed
D
G
E
F
I
H
G. Cancel
H. Temp/Time
I. Broil
J. Bake
K. Broil indicator light
L. Timer Set/Off
Publicidad
