Publicidad
Idiomas disponibles
Idiomas disponibles
4. Close the oven door and open the grill door (models where
apply). If the range have a Broiler Cap open oven door and
remove the shelf on the bottom of the oven, be sure while
handling.
Grab the shelf from both sides on the back part (see image),
pull out and remove. The flame should flow from all over the
openings on the burner. Normally the flame should look blue,
steady and 1 cm tall. Otherwise see the section "Flame
Adjustment", "Oven Burner Flame".
A. Shelf
B. Burner opening
5. After the oven burner checkup and adjustment of the flame,
turn the knob to the off position and if you have removed
shelf replace the bottom shelf to its original location.
6. After all these steps your oven is ready for use.
If the flame doesn't light up check the following:
1. Turn the knob to the off position (initial position) and make
sure the gas supply valve is open. Check the gas piping for
kinks or other damage on the line.
2. Repeat the procedure from step 3.
Flame Adjustments
Cooktop Burner Flame
When converting your range from Propane gas to Natural
gas, you will need to adjust some components to get the best
performance from your appliance.
Contact a qualified Whirlpool technician for this fix.
Oven Burner Flame
The different altitudes from the sea level, the variations on the gas
supply line and the type gas conversion may cause the need to
adjust the primary air intake in the oven burner for an adequate
air-gas blend, and therefore a better performance of the burner.
8
The oven burner flame should be blue colored and steady, follow
these steps to adjust the flame:
1. Check the range is cold and all the cooktop burners are in the
OFF position.
2. Unplug the range or turn off the power supply. Remove
the shelf on the bottom of the oven. Grab the shelf from
both sides on the back part (see image below), pull out and
remove.
3. Locate the screw that holds the burner to the frontal range
chassis and use a small flat screwdriver to remove it. Place
the screw in a safe place.
4. Hold the burner and pull it off to release the back part from
the nozzle, try not to pull the pigtail on the back if your range
is equipped with electronic ignition.
5. To adjust the air, loose the air regulator screw located behind
the burner and turn to open or close the air window (see
image).
A. Oven burner
B. Screw
C. Air regulator
6. If the flame is yellow you need to open the window. When
the flame is noisy or levitates our of the burner you need to
slightly close the window.
7. When the adjustment has been done, tighten the air regulator
screw and set the burner to its original position, align with
the nozzle on the back and make sure the pigtail is set to the
back of the range.
8. Place the screw with the washer holding the frontal range
frame and the burner. Tighten the screw.
9. Connect the power cable or turn on the power supply.
10. Turn on the burner again following the steps on section
"Testing your Range", "Oven Burner". If the flame is steady
and blue, the range is ready to use. Otherwise wait until the
range is cold and return to step 3.
11. When the oven burner has been adjusted and placed inside
the oven, replace the bottom shelf to its original location.
Continue with the oven burner testing.
NOTE: Don't block the air outlet of the oven, don't wrap or cover
the vents in the oven shelf.
Publicidad
