Publicidad
Idiomas disponibles
Idiomas disponibles
Getting started
Features and appearance will vary.
D
H
Power -
Press to "wake up" the display. If the display is active, press to put the Combo into standby "OFF" mode.
A
NOTE: Pressing Power does not disconnect the appliance from the power supply.
WASH and DRY - By default, the Combo selects a complete WASH and DRY for each cycle. You can choose
B
to run a WASH only by deselecting the DRY button. Vice versa, you can choose to run a DRY only cycle by
deselecting the WASH button. If you start a WASH only cycle, you can always add DRY prior to the completion
of the cycle.
Start and Pause
C
unlock the door. It may take a few seconds for the door to unlock after pressing Pause. Press again to restart
the cycle.
NOTE: If the Combo is paused with the door open and the cycle is not restarted within 15 minutes, the current
cycle will be canceled. If the Combo is paused with the door closed and the cycle is not restarted within 24 hours,
the current cycle will be canceled. In both cases, the Combo will drain the water in the tub after the cycle is
canceled.
NOTE: The Combo will perform automatic system checks after pressing the Start button. Water will flow in 45
seconds or less. You may hear the door lock and unlock and the pump activate before water flows.
Cycles -
The cycles are designed for specific types of wash loads. The chart below will help you match the
D
items to be washed with the best cycle settings. For optimal performance, select the cycle that most closely
matches the items being washed. Delay Start/Remote Start is available on all cycles.
When DRY is also selected, the Combo will deliver a low temperature Sensor Dry for the garments in the load
after it has completed the tailored wash cycle. The drying process for all cycles are similar to each other as they
are for a DRY only operation.
6
B
A
WASH
DRY
E
- Press to start a cycle. If the Combo is running, pressing it once will pause the Combo and
C
C
C F
C G
49-3000353 Rev 3
Publicidad
