Vortice VORT HRI PHANTOM BP Manual De Instrucciones página 31

ENGLISH
Vort HRI Phantom electrical connections:
7
MAINS
220-240V
~50Hz
2
3
4
5
• The power cord must be PVC sheathed cord (model 60227 IEC 53 (RVV), meet the requirements of GB/T 5023.5-
2008/IEC 60227-5:2003, with CCC certificate for chinese market).
• The three power cable conductors must have a nominal cross-section of no less than 0.75 mm
connected to the earthing terminal of the device.
• To connect the HMI remote display or the remote modbus master unit to the machine, use cables with a section between
0.35 mm 2 and 2.5 mm
the power cables, if there are problems of electromagnetic interference from other devices installed in the environment
(which produce malfunction of the display), it is recommended to use shielded cables.
• To connect the pre-heater and post-heater, use cables with a minimum section of 0.5 mm
1
PE
L
N
220-240V
~50Hz
VCC
A
B
GND
2 . Max length 30 m. Given that the display connection cable should be kept separate or away from
BU
BN
1 Mains 2 poles switch
Preheater
2
(remote 220-240Vac ~50Hz relay coil )
3 Dry contact (remote switch / relay )
4 Remote HMI
5 Remote Modbus Master Unit
GNYE
BN
L MAINS
BU
N
N
PREH
PREH
BOOST
BOOST
GND
VCC
A
HMI
B
GND
A
B MODBUS
GND
Wires color code
BK=black
BU=blu
BN=brown
GNYE=yellow/green
RD=red
WH=white
YE=yellow
2
.
2
and a yellow-green core
31