Publicidad
Step 15
å
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the mounting
screw is against the stops as shown in the right diagram. If it
isn't, loosen the mounting screw to slide it against the stops.
Then tighten the mounting screw.
å
Fasten the HINGES (4) on the DOOR (F) to the LEFT END (C)
as shown in the lower diagram. Use eight SILVER 1/2" FLAT
HEAD SCREWS (18).
å
Fasten the KNOB (11) to the DOOR (F). Use one 13/16"
MACHINE SCREW (16)
11
13/16" MACHINE SCREW
(1 used for the KNOB)
Page 21
F
16
www.sauder.com/service
C
Mounting screw (depth)
Adjusting screw (horizontal)
18
SILVER 1/2" FLAT HEAD SCREW
(8 used for the HINGES)
425667
Publicidad
