Descargar Imprimir esta página

Hansgrohe PuraVida 15771 1 Serie Instrucciones De Montaje página 2

Ocultar thumbs Ver también para PuraVida 15771 1 Serie:

Publicidad

Service Stops / Butées d'arrêt
d'isolation / Cierres de servicio

English
Technical Information
Recommended water pressure
Max. water pressure
Recommended hot water temp.
Max. hot water temp
Flow rate @ 44 psi
*Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
For best results, Hansgrohe recommends that
this unit be installed by a licensed, profes-
sional plumber.
Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
This trim is for use with iBox Universal Plus
model 01850181 (not included).
To prevent scald injury, the maximum output
temperature of the shower valve must be
no higher than 10°F. In Massachusetts,
the maximum output temperature can be no
higher than 11° F.
closed
Keep this booklet and the receipt (or other
ferme
proof of date and place of purchase) for
cerrado
this product in a safe place. The receipt is
required should it be necessary to request
warranty parts.
open
Inspect the check valves and filters at least
ouvert
once per year. Replace if dirty or worn.
abierto
Should the volume of water decrease over
time, inspect and clean the filters on the
thermostatic cartridge. After reassembly, set
the high temperature limit stop and justify the
handle.
To prolong the life of the themostatic
cartridge, regularly run it through its full range
of temperatures.
15 - 75 psi
145 psi
10° - 140° F*
176°F*
8 gpm

Publicidad

loading