Publicidad
Idiomas disponibles
Idiomas disponibles
Once the fireplace heater has been
properly installed to the mantel, plug the
fireplace into a 15AMP/120 Volt outlet. If
the cord does not reach you may use an
extension cord rated for a minimum of
1875 WATTS.
Note: Every time the electric heater is
plugged in, it will beep once. This means
the heater has connected to the power
outlet. The Electric Fireplace Heater is
ready to operate. Note: ensure the circuit
breakers for the power supply are turned
on. The electrical fireplace heater can
be operated by the control panel and
operated by the remote control. See the
following:
OPERATION BY THE
CONTROL PANEL
FIRE: Press this button for flame effect.
The unit will beep and the indicator light
above the button will be on. The bulbs for
Flame Effect & Log-set will be on.
Pressing again will stop the flame effect.
NIGHTLIGHT: Press this button once for night
light effect. The unit will be beep and the
indicator light will be on. The 2 pcs night light
bulbs will be on. Pressing button again will
stop the nightlight function.
O P E R A T I O N
5
750W: Press this button for low heat level.
The unit will beep, the pilot light and indi-
cator light will be on. The fireplace heater
will give low heat level. Pressing once
again will stop the low heat level function.
1500W: Press this button for high heat
level. The unit will beep, the pilot light and
indicator light will be on. The fireplace
heater will give high heat level. Pressing
once again will stop the high heat level
function.
HEAT TEMPERATURE CONTROL KNOB: To
adjust the temperature to your individual
requirements, turn the temperature con-
trol dial to the right (clockwise) to increase
the desired temperature and to the left
(counter clockwise) to lower the tempera-
ture.
May not be exactly as shown.
Publicidad
