decorflame QCM202-50 Manual De Instrucciones página 8

M A I N T E N A N C E
REPLACING THE
NIGHTLIGHT EFFECT
LIGHT BULBS
Step 1: Loosen the 8 screws on both sides
of insert (4 screws on each
side) and remove the metal frame.
Step 2: Loosen the 4 screws and retaining
tabs, and remove the glass panel.
Step 3: Locate the 2 x 7W Type C7 bulbs
for nightlight effect inside the
top section of cabinet.
Step 4: Loosen and remove the burnt out
bulb(s) and replace with new bulb(s).
Step 5: Replace the glass panel and se-
cure into place using the 4 screws
and retaining tabs.
NOTE: Make sure the rubber gaskets are
still attached to the glass panel.
May not be exactly as shown.
Step 6: Install the metal frame and secure
into place using the 8 screws.
Step 7: Plug in the unit.
8