Publicidad
Idiomas disponibles
Idiomas disponibles
To find out more about your product, consult the online EPREL database. As defined in Commission
Delegated Regulation (EU) 2019/2016, all information relating to this refrigeration appliance is available
on the EPREL Base (European Product Database for energy labeling). This database enables you to
consult the information and technical documentation of your refrigeration appliance. You can access the
EPREL Database by scanning the QR code on the energy label of your appliance or by going directly
to: www.ec.europa.eu and searching the reference of your refrigeration appliance.
2. INSTALLATION INSTRUCTIONS
Location
When selecting a location for your appliance you should make sure the floor is flat and firm, and the
room is well ventilated. An average ambient temperature must be observed. This temperature is specific
according to the climatic class of the device. ST: This refrigerating appliance is intended to be used at
ambient temperatures ranging from 16 °C to 43 °C.
Avoid location near a heat source, eg, cooker, boiler or radiator. Also, avoid direct sunlight in out-
buildings or terraces/outside seating areas. If you are placing your appliance in an out-building such as
a garage or annex ensure that it is placed above the damp course, otherwise condensation will occur
on the cabinet. Never place the appliance in a wall recessed or into fitted cabinets or furniture
when it is working, the metal grid at the back may become hot and the sides warm. You must leave at
least 10 cm (3.93 in) of free space at the back, 5 cm (1.96 in) on the sides and 20 cm (7.87 in) above.
Leveling the appliance
If your appliance is not leveled, the door and magnetic seal alignment will be affected and
may cause a malfunction. Once the appliance is placed in its final location, adjust the
leveling feet at the front by turning them.
Cleaning before use
Wipe the inside of the appliance with a weak solution of bicarbonate of soda. Then rinse with warm
water using a damp sponge or cloth. Wash the baskets and shelves in warm soapy water and dry
completely before replacing them.
Before plugging in
Check that you have a socket which is compatible with the plug supplied with the appliance.
DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE APPLIANCE.
The coolant fluid needs time to settle. If the appliance is switched off at any time, wait 30 minutes before
switching back on to allow the coolant fluid to settle.
Before filling your appliance
Before storing foods in your appliance, turn it on and wait for 24 hours, to make sure it is working properly
and to allow it to reach the correct temperature.
3. USE INSTRUCTIONS
Temperature setting:
To control the internal temperature, adjust the control dial according to the ambient temperature or
purpose of use.
The first time you turn the unit on, set the temperature control to "6."
19
Publicidad
