Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Procedure
7. Fully tighten the bolts once the bidet seat is in
correct position.
Connecting water hose
1. Close the water supply shut off valve to shut
off water into the tank. Remove as much water
from the tank as is possible so it doesn't spill
out when removing the supply line hose and
remove the hose to the tank. Connect the
T-Shaped adapter to the inlet valve of the tank.
2. Reconnect water supply hose to T-Adapter
and fully tighten.
Prohibited
1. Do not lift the product with seat cover and seat open.
2. Cannot use with hot water where temperature is higher
than 104˚F. This may cause operational issues.
8. Reinstall the bidet seat until it fully clicks into
position.
Water supply hose from Shut
Off valve to toilets tank.
T-Shaped Adaptor
5
Water Shut
Off Valve
760416-100EN Rev. 1 6/22
Publicidad
