Hoshizaki FM-481AGE-HC Manual De Instrucciones página 4

* Do not damage the power cord or pull it in
order to disconnect the icemaker from the
feed network.
* Do not touch the electrical parts or operate
the Operation Switch with damp hands.
* T h i s a p p l i a n c e i s n o t s u i t a b l e f o r
unsupervised use by young children or
aged or infirm persons.
* Do not attempt to modify the icemaker.
Only qualified personnel may disassemble
or repair the appliance.
3. All parts are factory-adjusted. Improper
adjustments may result in failure.
4. If the unit is turned off, wait for at least 3
minutes before restarting the icemaker to
prevent damage to the Compressor.
1. START UP
The installer will normally commission the icemaker
to start the automatic icemaking process. To ensure
continuous operation, make sure that:
* The water supply tap is on, and
* The icemaker is connected to the power supply.
To start the icemaking process, check the position of
the Operation Switch on the Operation Panel:
"OFF" position - Move it to the "ON" position.
"ON" position - Press the Ice Button.
Ice Button Display
ICE
DRAIN
STOP
MODE
ICE STOP RESET
Once STOP Button is pushed,
ICE Button cannot start ice
production for 20 min.
Operation Panel
Fig. 1
2. SHUT DOWN
Push the Stop Button on the Operation Panel. The
Display will blink in the "STOP" mode for 5 minutes
during the drain control operation and will start to
illumintate constantly at the end of drain control.
Stop Button
Reset Button
Operation Switch
3. PREPARING THE ICEMAKER FOR LONG
STORAGE
) Follow the instructions in "2. SHUT DOWN".
2) Move the Operation Switch to the "OFF" position.
3) Close the water supply tap.
4) Remove the Inlet Hose from the water tap, and
drain the Hose.
5) Disconnect the power supply.
6) Remove all ice from the Storage Bin, and clean
the Bin.
III. MAINTENANCE
1. CLEANING
WARNING
. B e f o r e c a r r y i n g o u t a n y c l e a n i n g o r
maintenance operations, disconnect the
icemaker from the electrical supply network.
2. This appliance must not be cleaned by use
of a water jet.
3. To prevent possible damage, do not clean
the plastic parts with water above 40°C or in
a dishwasher.
[1] Machine and Bin Exterior
Wipe the exterior at least once per week with a
clean, soft cloth. Use a damp cloth containing a
neutral cleaner to wipe off grease or dirt.
[2] Scoop Cleaning/Sanitisation (Daily)
) Either mix  litre of water with 4 ml of 5.25%
sodium hypochlorite solution in a suitable
contai ner, or the recomm ended Hoshi zaki
sanitiser as directed.
2) Soak the Scoop in the solution for more than 3
minutes. Rinse thoroughly, and shake to remove
surplus liquid.
Note: Using a cloth to dry may re-contaminate.
3
ENGLISH