Upper Threading - Brother XL-6452 Manual De Instrucciones

Tabla de contenido

Publicidad

31
1
2
4
5
3
1. Raise the presser foot using the Presser Foot Lever.
2. Raise the needle to its highest position by turning the balance
1
3. Place a spool of thread on the horizontal spool pin and press a
4. Deliver the upper thread as shown in this diagram.
5. Make sure to guide the thread through the thread take-up lever
6. Place thread behind the guide above the needle.
NOTE:
If the thread take-up lever is lowered, the upper thread can not be
wrapped around the thread take-up lever. Be sure to raise the
Presser Foot Lever and the thread take-up before feeding the upper
thread.
Incorrectly feeding the thread may cause sewing problems.

Upper Threading

wheel toward you (counterclockwise).
1 Presser foot lever
spool cap onto the spool pin to hold the thread spool firmly in
place.
The thread end should come from the bottom front of the spool.
CAUTION
If the thread spool and/or spool cap are set incorrectly,
the thread may tangle on the spool pin and cause the
needle to break.
Use the spool cap (large, medium, or small) that is
closest in size to the thread spool. If a spool cap smaller
than the thread spool is used, the thread may become
caught in the slit on the end of the spool and cause the
needle to break.
CAUTION
Be sure to thread the machine properly. Improper threading
can cause the thread to tangle and break the needle, leading
to injury.
from the right to the left.
2 Thread take-up lever

Publicidad

Tabla de contenido
loading

Tabla de contenido