Descargar Imprimir esta página

Simpson MS60850 Manual De Instrucciones página 11

Publicidad

Idiomas disponibles

Idiomas disponibles

K.
5n1 Multi-tip Nozzle
BASIC ELEMENTS OF AN ENGINE
Refer to the Engine Owner's Manual for location and operation of engine controls.
Choke Control: Opens and closes carburetor choke valve.
Starter Grip: Pulling starter grip operates recoil starter to crank engine.
Engine Switch: Enables and disables ignition system.
1.
Locate and remove all loose parts from the carton.
2.
Cut four corners of the carton from top to bottom and lay the panels flat.
3.
Place handle (G) onto frame (H), depress the snap
buttons, and slide the handle assembly onto the frame
until snap buttons snap into place.
NOTICE: Risk of personal injury. Avoid placing hands
between handle and frame when assembling to prevent
pinching.
4.
Connect wand (E) to gun (D). Tighten securely.
5.
Attach high pressure hose (C) to gun (D). Tighten se cure ly.
D
NOTICE: The engine is shipped without oil. Before starting engine, add the oil
provided. Damage to the engine will occur if the engine is run without oil, this
damage will not be covered under warranty.
NOTE: The pump on this unit is maintenance free and requires no oil. If
there is a problem with the pump, contact our Customer Service Group on
www.simpsoncleaning.com as soon as possible.
PRESSURE WASHER TERMINOLOGY
PSI: Pounds per Square Inch. The unit of measure for water pressure. Also used
for air pressure, hydraulic pressure, etc.
GPM: Gallons per Minute. The unit of measure for the flow rate of water.
CU: Cleaning Units. GPM multiplied by PSI equals CU.
Bypass Mode: Allows water to re-circulate within the pump when the gun trigger is
not pulled. This feature allows the operator to release the trigger gun and reposition
themselves without having to turn the engine off in between cleaning actions.
ASSEMBLY INSTRUCTIONS (FIG. 2–4)
3
4
E
OPERATION
11 - ENG
2
G
H
D
C

Publicidad

loading