Descargar Imprimir esta página

Honeywell MM14CHCS Manual Del Propietário página 11

Publicidad

Idiomas disponibles

Idiomas disponibles

Touch Screen Control Panel
Timer Control
Fan Speed Control
Power Control
The Power Control turns the unit on and off.
Mode Control
3 settings: Cool, Dehumidify and Fan
A light will indicate which setting is currently being used.
• Cooling Mode
The unit works as an air conditioner. Adjust fan speed and air
temperature to suit your desired comfort level. Temperature
setting range is 61°F~89°F.
• Dehumidifying Mode
Air is dehumidified as it passes through the unit, without being in
full cooling mode. If room temperature is higher than 77°F
fan speed can be adjusted; otherwise fan speed is preset to LOW.
Note : If the unit will be used mainly as a dehumidifier, do not
connect the exhaust hose and let the warm air return in the
room. Continuous drainage is then necessary and more
efficient (refer to page 14, Continuous Draining).
• Fan Mode
For air circulation without air conditioner cooling.
• Heating Mode
When heating mode is selected the indicator light will shine.
Heating is activated only when the ambient temperature is
below 77°F . In this mode, the desired temperature can be set
between 61°F and 77°F.
Note: The air exchange hoses must vent outside the room when
using heating mode.
Note: unit does not need to be vented in Fan mode.
After switching the air conditioner off, you must wait 3 minutes before switching it back on again.
Timer / Temperature Set Controls
Fan Speed Control
3 settings: High, Medium and Low.
Timer Control
Auto turn off:
While unit is running, press the Timer Control button to select the
number of hours you want the unit to run in air conditioning mode.
Auto turn on:
When unit is in a standby mode, press the Timer Control button to
select the number of hours until you want the unit to automatically
start running.
Temperature / Timer Set Controls
• Used for adjusting the timer and thermostat.
• The default display is room temperature.
• In cooling mode, when
temperature is displayed and may be adjusted.
After 10 seconds the display will revert back to room temperature.
Temperature is only adjustable in cool mode.
The time is adjustable between 1~24 hours.
Note : By pressing both
time, the display will toggle between Celsius and Fahrenheit.
Warning Light
Condensed water may accumulate in the unit. If the internal tank
becomes full, the Power Light will flash and the unit will not
operate until the unit has been drained (refer page 14, Water
Condensation Drainage).
USE & OPERATION
STOP
or
button is pressed, the set
/
set buttons at the same
Warning Light
(when flashing)
Power Control
Mode Control
10

Publicidad

loading