Toto TES201AA Manual De Instalación Y Del Propietario página 11

CARE AND CLEANING
For Light Cleaning
Please use a cloth that has been soaked in water
and wipe away any debris adhering to the
dispenser or sensor.
For Heavy-Duty Cleaning
After wiping away debris with a cloth containing a
suitable amount of a neutral, dishwashing
detergent, wipe clean with a damp cloth.
When cleaning around the sensor, please be
careful not to scratch the surface of the sensor.
Please avoid using cleansers that might scratch
the surface of dispenser.
These include:
Detergents containing acid, chlorine bleach or
alkali.
Solvents like paint thinner or benzene.
Detergents with coarse granules, polishing
powder or cleanser. Nylon scrubbers, pot
scrubbers, brushes, etc.
Sensor surface
Dispenser spout
20
PERIODIC MAINTENANCE - Nozzle
1. Pull out the power plug.
2. Turn the nozzle by hand to unlock.
3. Grab the projection on the nozzle with a
tool such as long-nose pliers and pull out
the nozzle and the filter.
4. Clean (Wash with water) the nozzle and the
filter.
Caution
If you wash the nozzle in a wash bowl, block
the drain outlet. This part is small and may be
lost.
Note
After washing them with water, wipe off
moisture with a dry soft cloth.
If you use hot water for cleaning, dirt is
washed off more easily.
5. After washing the nozzle and the filter,
mount them back again.
When mounting the nozzle, turn it by hand
so that it locks with the spill hole to the
lower side.
* The nozzle is made so as not to insert
reversely.
Note
After the nozzle has been mounted, turn on
the liquid soap, and make sure that water does
not leak from the outside of the nozzle.
Unlock
Nozzle
O-ring
Filter
Tool
● How to mount the nozzle
View from below
Spill ports
* Be sure to mount the nozzle so that the spill
hole comes to the lower side. Otherwise,
liquid soap may leak.
21