Toto TES201AA Manual De Instalación Y Del Propietario página 13

PERIODIC MAINTENANCE - Inside the Tank
5. Wash the tank.
6. Put the tank back in the original position.
7. Mount the float switch and the tank joint.
8. Mount the cover, the ring and the cap of
supply port.
9. Mount the bracket from the bottom of the
tank.
Once a month
Check all tube connections for any signs of leakage.
Twice a year
Check all fixed connections and tighten as needed.
(Continued)
Cap nut
Supply port cap
Float switch
Ring
Tank joint
Cover Tank Bracket
24
LONG-TERM NON-USE
If there will be long periods of time where the dispenser will not be used, remove all soap from
dispenser using the following method.
1. Remove soap from tank and wash tank out with water.
2. Fill the tank with water and set up the dispenser as usual.
3. Flush the line with water by activating dispenser until no soap comes out from spout.
Refill the tank with water if necessary.
4. Discard any water left in tank and allow tank to dry.
5. Disconnect the power supply until use resumes.
TROUBLESHOOTING
Problem Operating
Soap is low
Red LED flashing
Obstruction in front of sensor window
Red LED lighting-up Pump is not working correctly
No soap
- Sensor window is dirty
comes out
-
Sensor window is disconnected
-
Power supply is disconnected
-
Tube is disconnected
Soap won't stop
Sensor window is dirty
-
running
- Air tube (blue) is disconnected
It doesn't dispense
mousse
- Soap viscosity is high
Soap comes out Soap will be automatic dispersed after 72
-
unexpectedly hours of non-usage to prevent clogging.
Amount of
- Soap viscosity is high
dispensed soap
- Filter is clogged
is small
Cause Solution
Fill tank with liquid soap
Remove the obstruction
-
Clean sensor window
Connect cable
Connect cable
Connect tube
Clean sensor window
Connect air tube
Change to TOTO approved liquid soap
-
Change to TOTO approved liquid soap
Clean filter
25