Publicidad
Idiomas disponibles
Idiomas disponibles
12
www.aeg.com
Problem
The compressor operates
continually.
Door is misaligned or inter-
feres with ventilation grill.
Door does not open easily.
The lamp does not work.
There is too much frost and
ice.
Water flows on the rear plate
of the refrigerator.
Possible cause
Temperature is set incorrect-
ly.
Many food products were
put in at the same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed cor-
rectly.
The appliance is not level-
led.
You attempted to re-open
the door immediately after
closing.
The lamp is in stand-by
mode.
The lamp is defective.
The door is not closed cor-
rectly.
The gasket is deformed or
dirty.
Food products are not wrap-
ped properly.
Temperature is set incorrect-
ly.
Appliance is fully loaded and
is set to the lowest tempera-
ture.
Temperature set in the appli-
ance is too low and the am-
bient temperature is too
high.
During the automatic de-
frosting process, frost melts
on the rear plate.
Solution
Refer to "Control Panel"
chapter.
Wait a few hours and then
check the temperature
again.
Refer to "Installation" chap-
ter.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door"
section.
Refer to installation instruc-
tions.
Wait a few seconds between
closing and re-opening of
the door.
Close and open the door.
Refer to "Replacing the
lamp" section.
Refer to "Closing the door"
section.
Refer to "Closing the door"
section.
Wrap the food products bet-
ter.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.
This is correct.
Publicidad
