Descargar Imprimir esta página

Taurus CG3HN/B Manual De Instrucciones página 26

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
DO not mix up the top and bottom.
The locating pins must fit exactly into the notches.
FOR EU PRODUCT VERSIONS AND/OR IN CASE THAT IT IS REQUESTED IN
YOUR COUNTRY:
ECOLOGY AND RECYCLABILITY OF THE PRODUCT
The materials of which the packaging of this appliance consists are included in a collection,
classification and recycling system. Should you wish to dispose of them, use the appropriate
public recycling bins for each type of material.
The product does not contain concentrations of substances that could be considered
harmful to the environment.
ANOMALIES AND REPAIR
Take the appliance to an authorised technical support service if product is damaged or other
problems arise. Do not attempt to disassemble or repair the appliance yourself as this may
be dangerous.
TROBLESHOOTING:
Some minor problems can be resolved as follows:
Problem
Not Ignited.
Badly ignited.
Noise made when
combusted and
ignited.
Flame goes out
when in use.
- This symbol means that in case you wish to dispose of the product once its
working life has ended, take it to an authorised waste agent for the selective
collection of Waste from Electric and Electronic Equipment (WEEE).
Probable cause
No spark.
The burner lid is badly assembled.
The gas supply is closed.
The gas supply is not completely
open.
The burner lid is badly assembled.
The ignition plug is contaminated
with alien substance.
The burners are wet.
The holes in the flame spreader
are clogged.
The burner lid is bad assembly.
The flame supervision device is
contaminated with alien
substance.
Product being cooked has boiled
over and extinguished the flame.
A strong draught may have blown
the flame out.
Solution
Check the electricity supply.
Assemble the lid correctly.
Open the gas supply completely.
Open the gas supply completely.
Assemble the lid correctly.
Wipe alien substance with a dry cloth.
Dry the burners lid carefully.
Clean the flame spreader.
Assemble the burner lid correctly.
Clean the flame supervision device.
Turn off burner knob. Wait one minute
and reignite zone.
Please turn off zone and check
cooking are for draught such as open

Publicidad

loading