Publicidad
Idiomas disponibles
Idiomas disponibles
48
PRODUCT USE
MIXING INSTRUCTIONS
1.
Put half of the gasoline you are going to use into a fuel canister.
2.
Add the synthetic oil for two-stroke engines.
3.
Close the canister and shake it tightly to mix the gasoline with the oil.
4.
Add the rest of the gasoline and shake the drum again.
5.
Put the fuel canister lid on and clean up any spilled fuel.
FILLING THE FUEL TANK
1.
Place the machine on a flat surface.
2.
Clean any dirt or impurities from the fuel filler flap.
3.
Remove the fuel cap and fill the fuel tank with fresh and clean fuel mixture.
4.
Replace the cover and tighten it securely.
5.
Clean up any fuel residue before restarting the machine.
•
Do not use fuel substitutes in your engine, such as ethanol or methanol, the use of such fuel will cause damage
and void any applicable warranties.
•
Two-stroke engines must be used with a 25:1 fuel mixture ratio.
•
It is normal for a new engine to emit smoke during the first 5 hours of use during operation.
•
Mix only the fuel you will need. Do not store fuel for more than 30 days.
•
Use only new unleaded 95 gasoline.
•
Never use old or contaminated fuel to mix with 2-stroke oil.
•
Do not overfill the fuel tank and do not allow dirt or water to enter.
THE ENGINE
CONTROL POSITIONS (COLD ENGINE)
1.
Move the power switch to position "I".
2.
Prime the engine by pressing the carburetor priming pump four or five times. You should see fuel inside the
priming pump.
3.
Choke the motor by moving the choke lever to the'closed' position.
CONTROL POSITIONS (HOT MOTOR)
1.
Move the power switch to position "I".
2.
Move the throttle lever to the "open" position
ENGINE START
1.
Place the tool firmly on the ground, making sure it is stable. Hold the handle with your left hand and grab
the starter cord with your right hand.
ATTENTION: The recoil starter may be damaged if abused.
•
Always grease the starter before attempting to start the engine.
•
Never pull the starter to its limit.
•
Always rewind the starter rope slowly.
2.
Pull the starter rope slowly until you feel the motor engage.
3.
Pull the starter rope quickly to start the engine.
Publicidad
