Publicidad
Idiomas disponibles
Idiomas disponibles
English
Suspension Hook (Fig. D)
WARNING: Remove nails from magazine before
making any adjustments or servicing this tool. Failure
to do so may result in serious injury.
WARNING: Disconnect battery pack from tool
before making any adjustments, changing
accessories, servicing, or moving the tool. Such
preventative safety measures reduce the risk of
starting the tool accidentally.
CAUTION: When not in use, place tool on its side
on a stable surface where it will not cause a
tripping or falling hazard. Some tools with large
battery packs will stand upright on the battery pack
but may be easily knocked over.
The D
WALT cordless nailers include an integrated
e
suspension hook
and can be attached to either side of
10
the tool to accommodate left- or right-handed users.
If the hook is not desired at all, it can be removed from
the tool.
To remove suspension hook
1. Remove battery pack from tool.
2. To switch the tool from right- to left-hand usage simply
remove the screw
16
from the opposite side of the tool
and reassemble on the other side.
3. Replace battery pack.
Fig. D
OPERATION
WARNING: If the tool has been dropped or you
suspect tool damage perform tool operation
check as defined in the mode selection section of
the manual. If it does not perform according to the
manual, stop using the tool and have it serviced at an
authorized D
WALT Service Center.
E
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. E)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
14
battery pack with the rails inside the tool's handle and slide
10
10
16
into the tool handle, align the
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button
16
and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. E
Proper Hand Position
WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the
main handle.
Mode Selection
WARNING: Always wear proper eye [ANSI Z87.1
(CAN/CSA Z94.3)] and ANSI S12.6 (S3.19) hearing
protection when operating tool.
The D
WALT cordless nailers are assembled in accordance
e
with the ANSI Standard SNT-101-2002.
The finish nailer is capable of firing nails using bump
actuation or sequential actuation. If you would like to
have the bump actuation mode disabled, have the tool
serviced by an authorized D
e
operating this tool, look at the selector switch to determine
the actuation mode. Read all instructions before selecting
actuation mode.
WARNING: Keep fingers AWAY from trigger when
not driving nails to avoid accidental firing. NEVER
carry tool with finger on trigger. In bump mode tool
will fire a nail if contact trip is bumped while trigger
is depressed.
Fig. F
10
Sequential Actuation
Use sequential actuation mode for intermittent nailing
where very careful and accurate placement and depth
control is desired. The sequential actuation mode provides
the maximum delivery of power for driving the longest nails.
To operate the nailer in sequential actuation mode:
14
WALT service center. Before
(Fig. F)
Publicidad
