Publicidad
Idiomas disponibles
Idiomas disponibles
English
Fig. H
8
Unloading the Tool (Fig. I)
WARNING: The trigger lock-off should always be
locked off whenever any adjustments are made or
when tool is not in use.
1. Pull and hold the pusher to the bottom of the magazine.
2. Tip the tool up until the nails slide freely out the back of
the magazine. Release the pusher.
3. Open the jam clear door on the nosepiece to verify
there are no nails remaining.
Fig. I
5
15
14
Adjusting Depth (Fig. J)
The depth that the fastener is driven can be adjusted using
the depth adjustment wheel
WARNING: To reduce risk of serious injury from
accidental actuation when attempting to adjust
depth, ALWAYS:
•
Remove battery pack.
•
Engage trigger lock-off.
•
Avoid contact with trigger during adjustments.
1. To drive the nail shallower
adjustment wheel
away from the nose of the nailer.
3
2. To sink a nail deeper
wheel
3
toward the nose of the nailer.
12
on the side of the tool.
3
, rotate the depth
, rotate the depth adjustment
Fig. J
Headlights (Fig. K)
There is a headlight
4
located on each side of the nailer.
Headlights turn on upon battery insertion, activation of
the trigger, or depressing the contact trip. The lights will
automatically shut off after 20 seconds unless tool remains
in use.
nOTE: These headlights are for lighting the immediate work
surface and are not intended to be used as flashlights.
lOW BATTERY inDiCATOR: The left-side headlight will
flash four consecutive times and then shut down to indicate
low battery.
JAMMED nAil inDiCATOR: The right-side headlight will
flash continually if a nail becomes jammed in the nosepiece
(see Clearing a Jammed Nail).
Fig. K
4
Clearing a Jammed Nail (Fig. A, H)
If a nail becomes jammed in the nosepiece, keep the tool
pointed away from you and follow these instructions
to clear:
1. Remove battery pack from tool and engage the trigger
lock-off.
2. Pull the pusher back and remove any loaded nails.
3. Lift the jam clearing latch
front door
15
.
4. Remove bent nail, using pliers if necessary.
5. If driver blade is in the down position, cycle stall release
lever
using enough force to fully slide it to the other
13
end of the slot in housings.
3
5
then pull up to open
Publicidad
