Publicidad
Idiomas disponibles
Idiomas disponibles
3.
Position the filter holder underneath the brew head, attach the filter holder by
first moving retainer clip back, position handle so that the handle lines up with
the unlocked icon " " on the brew head and fits into the groove. Then, slowly
turn the handle to the right until it lines up with the locked position (indicated by
the icon below).
BREWING ESPRESSO
1.
Make sure the drip guard is in place on the drip tray. Place the drip tray in the unit.
2.
Make sure the control knob is in the off " " position.
3.
Place the cup or two cups (demitasses) under the filter holder or if you prefer,
place a small jar or carafe. If you wish to prepare up to 4 cups at a time, you
should use a small jar, carafe or regular cup and then pour the espresso into the
individual demitasses. If you will be brewing up to two demitasses at a time, you
can place the two small cups under the filter holder ensuring each one of them
is directly under one of the two outlet spouts located under the filter holder.
4.
Plug the power cord into an electrical outlet and turn the On/Off " / " Switch to the
on " " position. The power indicator light will become solid red while the unit is on.
5.
Turn the Brew/Steam Switch and make sure it is on the brew " " position.
When the brew indicator is solid green, rotate the control knob counter-
clockwise to the brew " " position.This will initiate the brewing process and
espresso will begin to flow in just seconds.
6.
When the cup/carafe is filled to the desired level, turn the control knob clockwise
to the off " " position. Using less water will provide a stronger espresso taste.
CAUTION: Do not leave unit unattended while brewing since the brewing
process requires to be manually stopped. This will avoid overflow, spillage and
potential hazards and damages.
7.
Once you have prepared the desired amount of espresso, turn the On/Off
" / " Switch to the off " " position and unplug the unit. Allow the unit to
cool down before removing parts and accessories prior to cleaning.
8.
After the unit has cooled down, remove the filter holder from the brew head.
Using the filter retention clip to secure the filter in the filter holder, turn the filter
holder upside down to remove the used espresso grounds. Rinse the filter and
filter holder with water.
9.
If you wish to brew additional espresso, repeat the process by following the
steps in the "HOW TO BREW ESPRESSO" section.
CAUTION: The metal parts of the filter holder might still be very hot. Make sure
to use the filter retainer clip when discarding the grounds. Cool these parts by
running under cold water.
10. For cleaning instructions, refer to cleaning your Espresso/Cappuccino maker section.
NOTE: If the unit has not been used for several days, it is recommended to prime the
unit for 30 seconds.
En glis h-7
Publicidad
