Publicidad
Idiomas disponibles
Idiomas disponibles
2610051956.qxp_ROS65VC 8/16/18 1:54 PM Page 11
FIG. 9
TRIGGER "ON-OFF" SWITCH
To turn the tool "ON" squeeze the trigger
switch. To turn the tool "OFF", release the
trigger switch, which is spring loaded and will
return to the "OFF" position automatically
(Fig. 1).
See START OF SANDING on page 12
"LOCK-ON" BUTTON
The "Lock-ON" button, located near the trigger
allows for continuous operation at maximum
OPM without holding the trigger (Fig. 1).
TO LOCK TRIGGER "ON": squeeze trigger,
depress button and release trigger.
TO UNLOCK THE TRIGGER: squeeze trigger
and release it without depressing the "Lock-
ON" button.
depressed, the trigger can not be released.
VARIABLE SPEED WITH DIAL SETTING
Your sander is also equipped with a variable
speed dial (Fig. 1). The sander's orbital pad
speed can be preset from zero to maximum
nameplate OPM by rotating the dial in the
VX120
DUST
PORT
Operating Instructions
If the "Lock-ON" button is
continuously
being
SERIES HOSE
BOSCH VAC-
SERIES HOSE
VAC024
SUCTION CONTROL
SLOT
housing. The dial may be set on or between
any of six positions (1=low through 6=high).
The following table may be used as a general
guide for abrasive and backing pad selection,
but the best results will be obtained by sanding
a test sample of the workpiece first.
Switch
Material
setting
rough/finish
woods:
softwoods
4 / 6
hardwoods
4 / 6
veneers
4
metals:
steel
4
stainless
4
aluminum
4/ 6
rust spots
6
paintwork:
sanding
2 / 3
scratches
4 / 6
stripping
4
-11-
BOSCH VH-
1-1/4"
OR
1-1/2" HOSE
Backing
Grit
pad
size
rough/finish
extra soft
60 / 240
soft
60 / 180
soft
240 / 320
soft
60 / 240
soft
120 / 240
soft
80 / 240
extra soft
60 / 120
soft
180 / 400
hard
120 / 240
soft
40/60 /80
Publicidad
