Publicidad
Idiomas disponibles
Idiomas disponibles
Protect this device from shocks and abuse. Avoid brute force when operating the device.
Familiarise yourself with the functions of the device before actually using it. Do not allow operation
by unqualified people. Any damage that may occur will most probably be due to unprofessional use
of the device.
All modifications of the device are forbidden for safety reasons. Damage caused by user modifications
to the device is not covered by the warranty.
Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, lamp explosion, crash, etc. Using the device in an unauthorised way will void the
warranty.
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and
the dealer will not accept responsibility for any ensuing defects or problems.
Mechanical wear and LEDs are not covered by warranty.
A qualified technician shall install and service this device.
Do not switch the device on immediately after it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room temperature.
This device is designed for professional use on stage, in discos, theatres, etc. The device shall only
be used indoors with an alternating current of 100-240 VAC, 50/60 Hz.
Lighting effects are not designed for permanent operation: regular operation breaks will prolong their
lives.
Use the original packaging if the device is to be transported.
Keep this manual for future reference.
4.
Features
Create stunning UV black light effects with the UV-TRACKER 12. The built-in programmes easily allow
you to create dimmer and strobe effects.
LED UV wash effect for real black light effects
loads of dimmer and strobe effects for new UV programming
sound-activation mode available to use your effect on the beats of the music
several nicely designed effects controlled in stand-alone mode
DMX control:
1-channel mode: dimmer
o
2-channel mode: UV1, UV2
o
3-channel mode: dimmer, UV1, UV2
o
4-channel mode: dimmer, shutter, UV1, UV2
o
5-channel mode: dimmer, shutter, UV1, UV2, colour adjustment
o
electronic dimmer 0-100 %
easy setting thanks to LED display
5.
Overview
Refer to the illustrations on page 2 of this manual.
1
display
2
DMX input
3
DMX output
4
control panel
6.
Installation
Choose a suitable mounting spot. Connect the power cord to the mains and switch on. Switch off and
disconnect after use.
V. 01 – 18/11/2014
VDPL1201UV
5
power input
6
power output
7
fuse
4
©Velleman nv
Publicidad
