KNF Labor N022.18 Manual De Instrucciones página 90

Setup and connection
Connected com-
ponents
Pump discharge 5. When using as a vacuum pump: Safely drain the pump
30
NOTICE
3. Connect the lines to the pneumatic inlet and outlet.
4. Only connect components to the pump that are designed
for the pneumatic data of the pump (see Chapter 3 Tech-
nical data [} 13]).
discharge at the pneumatic outlet of the pump.
6. Lay the line at the pneumatic inlet and the line at the
pneumatic outlet in a downward slope so that no conden-
sate can run into the pump.
7. Plug the plug of the power cable into a properly installed,
grounded socket.
Translation of Original Operating Instruction, KNF 121224-121388 04/23
Diaphragm pump N022.18, N026.18
If the pump is used as a vacuum
pump, install a silencer on the pressure
side if necessary.
If the pump is used as a compressor
(not for pumps with .3 connection), in-
stall an inlet filter on the suction side if
necessary.