KNF Labor N022.18 Manual De Instrucciones página 95

Diaphragm pump N022.18, N026.18
Tool Quantity Tool/material
Information on
the procedure
Translation of Original Operating Instruction, KNF 121224-121388 04/23
1 Allen key, 3 mm
1 Allen key, 4 mm
1 Screwdriver blade width 6.5
1 Screwdriver blade width 4.0
1 Socket wrench 5.5 mm
1 Pencil
Tab.24: Tool
The diaphragm and valves are the only wearing parts in the
pumps. They are easy to replace.
The valves and diaphragm should generally be replaced at
the same time. If the diaphragm is not replaced at the same
time as the valves, the specified output of the pump can no
longer be ensured after the maintenance is performed.
With multi-headed pumps, parts may be interchanged be-
tween the individual pump heads.
à
Replace the diaphragm, valve springs and seals of the in-
dividual pump heads in sequence.
WARNING
Health hazard due to dangerous sub-
stances in the pump
Depending on the medium being trans-
ferred, caustic burns or poisoning is
possible.
à
Wear protective equipment if nec-
essary, e.g., protective gloves,
goggles.
à
Clean the pump with suitable mea-
sures.
Servicing
DE
EN
FR
ES
IT
35