Publicidad
Idiomas disponibles
Idiomas disponibles
English
A ......................... amperes
W ........................ watts
or AC ........... alternating current
or AC/DC .... alternating or
direct current
...................... Class II
Construction
(double insulated)
n o ....................... no load speed
n ......................... rated speed
...................... earthing terminal
..................... safety alert symbol
Motor
Be sure your power supply agrees with the nameplate
marking. Voltage decrease of more than 10% will cause loss
of power and overheating. These tools are factory tested; if
this tool does not operate, check power supply.
Intended Use
This pressure washer is intended for cleaning boats, cars,
decks, driveways, grills, house siding, motorcycles, patios,
and outdoor furniture.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Specifications
Maximum Pounds per Square Inch
Rated Gallons per Minute*
Electrical Requirements
Electrical Cord
High Pressure Hose
Minimum Amp Source
Pressure of Inlet Water*
Inlet Water
Soap Consumption Rate
*Water flow and maximum pressure ratings determined in accordance with
CETA CPC-100.
4
..................... visible radiation
..................... avoid staring at
light
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
..................... read all
documentation
IPXX .................... IP symbol
2,400
1.1
120V
~60Hz, 13A
AC
35 ft. (10.6 m)
25 ft. (7.6 m)
15A
20-100 PSI
Cold Tap
10% MAX
Assemble Frame Handle (Fig. A–C)
Your pressure washer is not fully assembled in the carton.
1. To assemble the frame handle
washer unit
7
, line the upper poles
poles
so the detent pins snap into position.
16
Fig. B
Fig. C
7
High Pressure Hose Storage Hook (Fig. D)
Your pressure washer is not fully assembled in the carton.
1. To assemble the high pressure hose storage hook
to the crossmember
the hook so it will slide between the retaining slots
on the rear of the crossmember
2. Release the pressure hose storage hook
detents
18
to rest securely in the retaining slots
3. Press the high pressure hose storage hook
locking detents
32
on the rear of the crossmember
until it clicks into place.
Fig. D
14
to the pressure
15
with the lower
19
, squeeze the detent end
19
.
17
allowing the
17
19
31
32
18
17
15
16
14
17
18
of
31
31
.
onto the
19
Publicidad
