Metrix GX-1030 Guia De Inicio Rapido página 19

Mod - Modulation function
The GX 1030 can generate AM, FM, ASK, FSK, PSK, PM, PWM and DSB-AM modulated waveforms. Modulating
parameters vary with the types of the modulation. In AM, users can set the source (internal/external), depth, modulating
frequency, modulating waveform and carrier. In DSB-AM, users can set the source (internal/external), modulating
frequency, modulating waveform and carrier.
Sweep - Sweep function
In the sweep mode, the generator steps from the start frequency to the stop frequency in the sweep time specified by
the user.
The waveforms that support sweep include sine, square, ramp and arbitrary.
Burst - Burst function
The Burst function can generate versatile waveforms in this mode. Burst times can last a specific number of waveform
cycles (N-Cycle mode), or when an external gated signals (Gated mode) is applied. Any waveform (except DC) may be
used as the carrier, but noise can only be used in Gated mode.
TO USE COMMON FUNCTION KEYS
Parameter
The Parameter key makes it convenient for the operator to set the parameters of basic waveforms directly.
Utility
Select the System Info option of the utility menu to view the generator's system information, including startup times,
software version, hardware version, model and serial number.
The GX 1030 provides a built-in help system, by which users can view the help information at any time when operating the
instrument. Press [Utility] → [System] → [Page 1/2] → [Help] to enter the following interface.
Store/Recall
The Store/Recall key is used to store and recall waveform data and configuration information.
The GX 1030 can store the current instrument state and user-defined arbitrary waveform data in internal or external
memory and recall them when needed.
The GX 1030 provides an internal non-volatile memory (C Disk) and a USB Host interface for external memory.
Ch1/Ch2
The Ch1/Ch2 key is used to switch the currently selected channel between CH1 and CH2. After start-up, CH1 is selected
as default. At this point, press the key to select CH2.
19